Guides
Genuine vs OEM vs aftermarket parts for HOWO and Shacman trucks: how to verify before you buy
How to tell genuine, OEM and aftermarket parts apart on HOWO / Sinotruk and Shacman trucks, with a checklist to verify a part before you pay.
- Prepared by
- CAP Parts Team
- Published
- Reading time
- 5 min read
- References
- 3 sources
Key takeaways
"Genuine", "original" and "OEM" are used loosely in the Chinese parts trade; ask every seller to say in writing which tier the part is and who made it.
A part number alone proves nothing: a non-genuine part can carry the same number, and even a logo, as the genuine one.
Verify before paying: written tier statement, part number matched to your VIN or chassis number, photos of the actual part and its packaging, and an invoice that names the part type.
A big gap to the going price is a warning, but a normal price does not prove a part is genuine. Judge on documents and photos, not price alone.
Aftermarket and OEM-factory parts can be good value on wear items if you buy them knowingly, with the quality grade and terms agreed in writing.
On this page
Short answer: In the Chinese truck parts trade, “genuine” normally means a part sold through the truck maker’s own spare-parts channel, “OEM” a part from the same type of factory sold outside that channel, and “aftermarket” or “copy” a part made by an independent factory to the same dimensions. You cannot tell them apart by the part number alone, so verify with a written tier statement, a number matched to your truck’s VIN, photos of the real part and packaging, and an invoice that says what you bought.
The three tiers in plain words
The words are used differently by different sellers, so fix the meaning before you negotiate. The table below follows how the trade describes the tiers (see the sources at the end); it is a guide to conversations, not a legal definition.
| Genuine / original | OEM (factory-direct) | Aftermarket / copy | |
|---|---|---|---|
| Typical source | Truck maker’s spare-parts department, or an authorised channel | A factory that makes the part, sold outside the truck maker’s channel | Independent factories and trading companies |
| What to expect | Best fitment consistency and traceability | Often the same type of factory, quality depends on batch control | Anything from good value to risky shortcuts |
| Price | Highest | Often lower than genuine | Lowest |
| Warranty reality | Most enforceable, if the paperwork matches the brand’s rules | Often limited, so ask how claims work | Usually relies on your purchase contract |
Two points from the trade are worth knowing. First, a truck maker does not make most parts on its own trucks. A 2015 explainer reposted by China Truck Times notes that Sinotruk buys many parts, such as injectors, from other factories, so a part can be “genuine” because of the channel it was sold through, not because the maker produced it. Second, the same explainer says that wholesalers who skip the maker’s channel buy from those same factories and sell “OEM” parts; and that small workshops make copies and fakes. DocShipper’s sourcing guide adds that “OEM” is sometimes used for aftermarket units in unbranded boxes. So “OEM” on a listing is a claim to check, not a grade.
Why the part number does not prove it
Volvo Trucks makes the same point for its own range: non-genuine parts “might look the same and have the same part number”, and in some cases carry the brand’s logo even though that is trademark infringement. The lesson applies to any make. A number and a logo tell you what the seller wants you to believe; the proof is in the paperwork, the maker’s markings you can compare and the seller’s willingness to be specific.
Verification checklist: before you pay
Work through this list for every first order and for any new seller. Ask for the answers in writing (email or chat), so you can refer back to them if there is a dispute.
- Tier in writing. “Is this genuine, OEM or aftermarket? Who manufactured it?” A seller who will not answer plainly is giving you the answer.
- Part number matched to your truck. Send the VIN or chassis number (see how to identify your truck) and ask the seller to confirm the part number against it, ideally against the parts book (see how to find the right part number).
- Photos of the actual part, not catalogue pictures: all sides, the face with the markings, the part number as it appears on the part, and a coin or ruler for scale.
- Photos of the packaging: the box, label, any printed number or barcode, how the part is wrapped. Compare these with a part you know is genuine, if you have one from your own dealer.
- Compare against your old part. Place the old and the offered part side by side in photos: mounting points, hole positions, casting or stamping marks, finish.
- Invoice and packing list that name the part, the quantity and the tier, not just “truck spare parts”. Check the part numbers on the invoice match the ones in your order.
- Batch or traceability information where it exists. DocShipper lists batch numbers and material certificates as things a serious factory provides without hesitation.
- Terms in writing: what happens if the part arrives wrong or fails early, who pays freight on a return, and how long you have to report a problem.
- Pay in steps where you can: a small first order, then larger ones once parts have run in your own fleet.
- Inspect on arrival before you sign off: count, photograph, compare with the pre-shipment photos, and keep the packaging until the part is fitted and tested.
Red flags
- The seller calls every item “100% original” but cannot name the maker or show paperwork.
- Catalogue photos only, or the same photo for different items.
- A price far below the going rate for a part that is “genuine”: the Chinese trade explainer above says even genuine prices can differ widely between items, so ask why before you accept it.
- The part number on the box differs from the number on the part, or from your order.
- Pressure to pay in full immediately, or reluctance to put the tier in writing.
Which tier to choose
There is no single right answer. For safety-critical parts (brakes, steering, wheel ends) and anything under warranty, many fleets prefer traceable parts and keep the paperwork. For plain wear items on older trucks, a known OEM-factory or good aftermarket part with clear terms can be a sound choice. The risk is not “aftermarket” itself, but buying a lower tier while being told it is a higher one. Decide per part, per truck age and per downtime cost, and write the decision into your order.
What to send us for a quote
Send the part number, the VIN or chassis number, or photos of the old part and your truck’s plates, and tell us which tier you want (or want us to quote more than one). We confirm the exact version for your truck and tell you what is and is not stated for each option. Use the quote page or contact us. Brand pages: Sinotruk / HOWO and Shacman.
Truck part groups to look at
Frequently asked questions
- How can I tell if a Sinotruk or HOWO part is genuine?
- Not from one feature. Ask the seller to state the tier and manufacturer in writing, match the part number to your VIN or chassis number, request photos of the real part and its packaging, and check the invoice names the part. Where possible compare with a part you know came through the maker's channel.
- What is the difference between OEM and genuine parts?
- In the Chinese trade, genuine usually means sold through the truck maker's spare-parts channel, while OEM means made by a factory of the same kind but sold outside that channel. Sellers use both words loosely, so ask for the exact meaning.
- Is an aftermarket truck part always worse?
- No. Quality ranges widely. A known factory with agreed terms can be good value on wear items. The problem is buying aftermarket while being told it is genuine, or buying without any quality terms.
- Does the same part number mean the same part?
- No. Volvo Trucks notes that non-genuine parts can carry the same part number and even the brand logo. Use the number to order, and use documents, photos and traceability to verify.
- Are genuine parts always more expensive?
- Usually the highest tier by price, and a very low price for a "genuine" part is a reason to ask questions. But a normal price does not prove genuineness either, so do not rely on price alone.
- What should I photograph when a parts order arrives?
- The sealed box and its labels, the part from all sides, the markings and part number on the part, and any damage. Keep the packaging until the part is fitted, so you can report problems with evidence.
- Can I ask my supplier to quote genuine, OEM and aftermarket versions?
- Yes, and you should for large orders. Ask for each option with the tier, maker (where stated) and terms, then compare on price, warranty terms and downtime risk.
Sources
- [1]Chinese truck parts sourcing guide (genuine, OEM and aftermarket table). DocShipper.
- [2]Original, OEM, copies and fake: any difference? (2015 repost). China Truck Times.
- [3]Genuine vs. non-genuine truck parts: how do they compare?. Volvo Trucks India.






